Specifications

22
Change Device Configuration
This function is used to modify the parameter of the Z-Wave device via
the configuration command class.
Look up the Parameter No. and Parameter Value of the target device
from the device user manual before you start the below process.
Step Setup Key LED Indication Status
1
Press
• “OK＂ LED stays on
2
Enter the Parameter
number from 0 to 127 in
front
• “OK＂ LED flashes
once and stays on for
each key press
3
Press
in front
• “OK＂ LED stays on
then flashes once
4
Enter the Parameter
value from -2147483648
to [phone] (32bits
value) in front
(For negative value,
press
)
• “OK＂ LED flashes
once and stays on for
each key press
5
Press
in front
• “OK＂ LED stays on
then flashes once
6
Press the program button
on the target device
• “OK＂ LED flashes
and turns off
• The configuration value
is saved to the device