Specifications

25
Transferring All Network and Device Information to a
New Primary Controller (Primary Shift)
You can transfer all of your controller information to another remote so
that it will become the new primary remote. This is done by following
the steps below.
Step Setup Key LED Indication Status
1
Press & hold
for 3 seconds
• “OK＂ LED on
2
Place the two controller
close to each other
3
Type “8361＂ on the
setup number keypad
• “OK＂ LED flashes
once for each number
input
• “OK＂ LED keeps
blinking after entering
the 4-digit
4
Please make sure the
target controller is setup
to receive information.
(Refer to the target
controller user manual
for more information)
• “OK＂ LED flashes
once then turns off
• Replication completed
Note 1: If this replication is unsuccessful, the “OK” light turns off and
the error light will flash 6 times then turn off.