Specifications

26
Transferring Only Network Information to a New
Primary Controller (Primary Shift)
You can just transfer network information to another remote so that it
will become the new primary remote. This is done by following the
steps below.
Step Setup Key LED Indication Status
1
Press & hold
for 3 seconds
• “OK＂ LED on
2
Place the two controller
close to each other
3
Type “8362＂ on the
setup number keypad
• “OK＂ LED flashes
once for each number
input
• “OK＂ LED keeps
blinking after entering
the 4-digit
4
Please make sure the
target controller is setup
to receive information.
(Refer to the target
controller user manual
for more information)
• “OK＂ LED flashes
once then turns off
• Replication completed
Note 1: If this replication is unsuccessful, the “OK” light turns off and
the error light will flash 6 times then turn off.