Specifications
29
Resetting Your Network
You can reset your Z-URC
TM
550EU to clear all Z-Wave network and
device information by the following steps:
Step Setup Key LED Indication Status
1
Press & hold
for 3 seconds
• “OK" LED on
2
Type “8761" on the
setup number keypad
• “OK" LED flashes
once for each number
input
• “OK" LED on after
entering the 4-digit
• “OK" LED blinking
then turns off
• Reset completed
Note 1: After reset the remote, each device should individually perform
in the section on “Delete device from the network” and “Add device to
the network”.