Specifications

32
Add/Delete Devices
Adding Device to the Network
Step Setup Key
LED Indication
Status on
Z-URC
TM
550EU
LED Indication
Status on
ZXT-300EU
1
Make sure
ZXT-300EU
switched to
Channel 1 (EP1)
-
• LED flashes
once then keep
on
2
Press in
Advance Setup
area
• Back “OK＂
LED and front
“OK＂ LED
turns on
-
3 Press
• “LED_B＂
flashes slowly
-
4
Press the PROG
button on ZXT-
300EU
• Back “OK＂
LED and front
“OK＂ LED
flashing then
turns off
• “LED_B＂ off
• Device inclusion
completed
• LED flashes
twice then
keep on
• Device
inclusion
completed
Note 1: Error LED in front or back on Z-URC
TM
550EU or ZXT-
300EU Red LED flashes 6 times means the setup process is failed.
Please redo the process again.
Note 2: If you can’t add your ZXT-300EU to network, it might has been
included in another Z-Wave network or the ZXT-300EU is not on
Channel 1 (EP1). In this case, please delete it following the steps in the
[Deleting Device from the Network] section then make sure ZXT-
300EU is on the Channel 1 (EP1) and add it again.
Note 3: This step can be skipped if the device is already existed in the
network.