Specifications

38
which you want to
transmit the IR
signal
on for each
key press
6
Press
• Front “OK＂
LED flashes
once and stays
on
-
7
Press the PROG
button on ZXT-
300EU
(The IR port
number has been
assigned to the EP1
as it is ACK by
EP1)
• Front “OK＂
LED flashing
then turns off
• Set IR Port
output
successful
• LED flashes 2
times then
keep on
• Set IR Port
output
successful
Note 1: Error LED in front or back on Z-URC
TM
550EU or ZXT-
300EU Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
Note 2: All the Simple AV Channel / Z-Wave-to-IR Channel will map to
“IR Port 1” in default if user has not go through the above setup
procedure or Z-Wave remote controller does not support “Multi-
channel Command Class”.
IR Output Power
Set IR Output Power Level for each IR port (except IR Port 1)
Step Setup Key
LED Indication
Status on
Z-URC
TM
550EU
LED Indication
Status on
ZXT-300EU
1
Switch ZXT-
300EU to your
target EP no.
such as EP1
-
• LED flashes
once then keep
on
2
Press in
Advance Setup
• Back “OK＂
LED and front
“OK＂ LED
turns on
-
3
Enter the
function code
"2", "8" in the
front
• Front “OK＂
LED flashes
once and stays
on for each key
press
-