Specifications

39
4
Press
• Front “OK＂
LED flashes
once and stays
on
-
5
Set IR output
power level by
entering “0＂
or “1＂ in the
front
“0＂ low power mode
“1＂ high power mode
(default is in
high power
mode)
• Front “OK＂
LED flashes
once and stays
on for each key
press
-
6
Press
• Front “OK＂
LED flashes
once and stays
on
-
7
Press the PROG
button on ZXT-
300EU
(The IR output
power has been
assigned to the
EP1 as it is ACK
by EP1)
• Front “OK＂
LED flashing
then turns off
• Set IR Power
level successful
• LED flashes
twice then
keep on
• Set IR Power
level
successful
Note 1: Error LED in front or back on Z-URC
TM
550EU or ZXT-
300EU Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
Note 2: IR port 1 is a fixed IR output power which is un-configurable
and operating in wide angle and long distance coverage.
IR Port Number IR Output Power Mode Default value
1 Un-configurable -
2 Configure as Low or High High
3 Configure as Low or High High
4 Configure as Low or High High
5 Configure as Low or High High
6 Configure as Low or High High
Table 2 IR Port Output Power