Specifications

41
once which you
want to learn the
command
once and stays
on
6
Press the PROG
button on ZXT-
300EU
(make sure the EP
is related to the AV
device name on
Z-
URC
TM
550EU)
-
• LED flashes
once then keep
on
7
Place the ZXT-
300EU and your
original remote on
a flat surface,
aimed at each other
1-3 inches apart
- -
8
Press and keep
holding the key on
your original
equipment remote
which you want to
learn for a few
seconds
• Front “OK＂
LED flashing
then turns on
• Learn a code
successful
• LED flashes
twice then
keep on
• Learn a code
successful
9
Repeat step 5 to 8
to learn other keys.
- -
10
Press any device
key to exit the
learn mode
(e.g. , ,
or )
• All LEDs off
-
Note 1: Error LED in front or back on Z-URC
TM
550EU or ZXT-
300EU Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
Note 2: On step 8, if no IR signal received for more than 15 seconds,
the Error LED in front will flashes six times then all LED turn off,
Learning on ZXT-300EU mode will exit automatically.