Owner Manual

20 | Page
Operation
DO NOT LEAVE YOUR GRILL UNATTENDED WHILE IN OPERATION.
Grill: Grill burners are controlled individually with control knobs. After
lighting, turn the knob to HI, LO or in between as desired. Turn on as
many burners as required. The top cover may be closed during
grilling. Keep the top cover in closed position during the pre heat
period.
If you have installed an optional infra-red burner in your grill, you must leave the lid
open while the infra red burner is in use, due to the intense heat it will generate!
Rotisserie: (Not included with all models) Plug in the motor power cord to a
properly grounded receptacle.
Rotisserie cooking can be done with grill burners as well as with the
Rotisserie burner ‘ON’. KEEP THE MOTOR STORED INDOORS
WHEN NOT IS USE.
Be sure to remove the upper grid in the back of your grill PRIOR to lighting
the rear burner!
The skewers slide in from the side with the tip sliding into the motor shaft
adapter. The slot on the handle side should be on the side support
panel edge.
Use the prongs to hold the meat. Tighten thumbscrew on the prong hubs to
secure in place.
When ready, turn the switch on the motor box to the ‘ON’ position. The
skewer will rotate slowly.
Stop the motor before removing the skewer.