Specifications

11A-49
TOP AND FRONT OF ENGINE
Camshaft: Removal - Refitting
K4M
11A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-2) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-4) ,
- the air resonator (see 12A, Fuel mixture, Air res-
onator: Removal - Refitting, page 12A-2) ,
- the timing belt (see 11A, Top and front of engine,
Timing belt: Removal - Refitting, page 11A-17) ,
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-6) ,
-the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-11) ,
- the inlet distributor (see 12A, Fuel mixture, Inlet
distributor: Removal - Refitting, page 12A-12) ,
- the ignition coils (see 17A, Ignition, Coils: Re-
moval - Refitting, page 17A-1) ,
- the rocker cover (see 11A, Top and front of en-
gine, Rocker cover: Removal - Refitting, page
11A-42) ,
- the timing end camshaft seals (see 11A, Top and
front of engine, Camshaft seal, timing end: Re-
moval - Refitting, page 11A-56) .
Equipment required
roller-type stud removal tool
Tightening torquesm
the camshaft dowel 8 N.m