Specifications

12A-11
FUEL MIXTURE
Throttle valve: Removal - Refitting
K4M
12A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove the air filter unit (see 12A, Fuel mixture,
Air filter unit: Removal - Refitting, page 12A-6) .
a Disconnect the accelerator cable at (1) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the throttle valve bolts (2) ,
- the throttle valve.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Throttle valve seal.
II - REFITTING OPERATION
a Refit:
- the throttle valve equipped with a new seal,
- the throttle valve bolts.
a Torque tighten the throttle valve bolts (13 N.m).
III - FINAL OPERATION
a Reattach the accelerator cable.
a Refit the air filter unit (see 12A, Fuel mixture, Air fil-
ter unit: Removal - Refitting, page 12A-6) .
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
Tightening torquesm
throttle valve bolts 13 N.m
116660
116635