Specifications

12A-13
FUEL MIXTURE
Inlet distributor: Removal - Refitting
K4M
12A
a
Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consum-
ables - Products) to clean and degrease:
- the housing of each inlet distributor seal if reused,
- the joint face of the injector holder shim.
a Fit new seals to the inlet distributor.
a When replacing the inlet distributor, refit:
- the air temperature sensor,
- the inlet distributor pressure sensor.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the inlet distributor,
- the inlet distributor mounting bolts.
a Torque tighten in order the intake distributor
mounting bolts (9 N.m).
III - FINAL OPERATION
a Refit the throttle valve equipped with a new seal (see
12A, Fuel mixture, Throttle valve: Removal - Re-
fitting, page 12A-11) .
a Clip the wiring onto the inlet distributor.
a Connect:
- the coil connectors,
- the air inlet pressure sensor connector,
- the air temperature sensor connector.
a Position the accelerator cable on the inlet distributor
and on the throttle valve.
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
WARNING
To ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
116653