Specifications

10A-12
ENGINE AND CYLINDER BLOCK ASSEMBLY
Lower cover: Removal - Refitting
K9K
10A
II - REMOVAL OPERATION
a Remove the power-assisted steering pump support
bolt (13) on the sump.
a Remove the bolt from the sump on the multifunction
support.
a Remove:
- the engine-gearbox coupling bolts (14) ,
- the sump bolts,
- the sump.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: engine oil sump
seal.
a parts always to be replaced: Front sub-frame
bolt.
STANDARD HEATING RECIRCULATION
24761
AIR CONDITIONING
107936
Note:
If the sump cannot be extracted because it is in
contact with the oil pump strainer, do not force
the removal of the sump as this may damage the
oil splash plate.
Loosen the oil pump bolts by a few turns (the tip
of your finger should pass between the bolt head
and the oil pump casing) using 10 mm and 13
mm open-jawed spanners and while tilting the
sump towards the front of the vehicle.
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.