Specifications

13B-38
DIESEL INJECTION
Accelerometer: Removal - Refitting
K9K
13B
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the accelerometer using.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the accelerometer.
a Torque tighten the accelerometer (20 N.m) using
the.
II - FINAL OPERATION
a Connect the accelerometer connector.
a Refit:
- the « pump-rail » high pressure pipe (see 13B,
Diesel injection, High pressure pipe between
pump and rail: Removal - Refitting, page 13B-
19) ,
- the dipstick guide.
a Torque tighten the dipstick guide and filler neck
nuts on the high pressure rail (21 N.m).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Program the accelerometer if replaced (see Fault
finding - Interpretation of faults) (13B, Diesel in-
jection).
a Check the high pressure circuit (see 13B, Diesel in-
jection, High pressure pipe: Check, page 13B-18)
.
a Refit the engine cover.
Note:
When replacing the accelerometer, run com-
mand RZ004 using the Diagnostic tool in order
to carry out the necessary programming.