Specifications

14A-2
ANTIPOLLUTION
Fuel vapour absorber: Removal - Refitting
K4M
14A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a lift (see Vehicle: Towing
and lifting) (02A, Lifting equipment).
a Remove the front right-hand wheel (see Wheel: Re-
moval - Refitting) (35A, Wheels and tyres).
a Move aside the front section of the front right-hand
wheel arch liner.
II - REMOVAL OPERATION
a Disconnect:
- the fuel vapour absorber pipes (1) ,
- the solenoid valve connector.
a Unclip the breather pipe (2) .
a Insert the blanking plugs.
a Remove:
- the fuel vapour absorber nuts (3) ,
- the fuel vapour absorber.
IMPORTANT
During this operation, be sure to:
- refrain from smoking or bringing red hot objects
close to the working area,
- be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
Keep the pipe unions away from contaminated
areas.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
Note:
The fuel vapour absorber is located behind the front
bumper, on the front right-hand side of the vehicle.
108415
108428