Specifications

14A-9
ANTIPOLLUTION
Exhaust gas recirculation assembly: Removal - Refitting
K9K, and 796
14A
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
- the air filter box (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-6) ,
- the engine undertray,
-the catalytic converter (see 19B, Exhaust, Cata-
lytic converter: Removal - Refitting, page 19B-
10) .
a Remove:
-the clip (1) on the air pipe between the intercooler
and the exhaust gas recirculation assembly,
-the clip (2) on the air pipe between the intercooler
and the turbocharger.
a Disconnect:
- the air pipe between the intercooler and the ex-
haust gas recirculation assembly,
- the air pipe between the intercooler and the turbo-
charger,
- the oil vapour rebreathing pipe (3) ,
- the non-return valve (4) at the vacuum pump,
- the exhaust gas recirculation solenoid valve con-
nector (5) .
Special tooling required
Ms. 583 Pipe clamps.
Tightening torquesm
bolts of the exhaust gas
recirculation assembly
21 N.m
bolts on the « timing
end lifting eye - air inlet
metal tube assembly »
10 N.m
IMPORTANT
Wear cut-resistant gloves during the operation.
24814