Specifications

14A-12
ANTIPOLLUTION
Exhaust gas recirculation rigid pipe: Removal - Refitting
K9K, and 796
14A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
-the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-6) ,
- the engine undertray.
a Remove the catalytic converter (see 19B, Exhaust,
Catalytic converter: Removal - Refitting, page
19B-10) .
a Remove:
- the bolts (1) from the lifting eye at the timing end,
- the timing end lifting eye (2) ,
II - REMOVAL OPERATION
a Remove:
- the bolts (3) of the exhaust gas recirculation rigid
pipe bracket from the cylinder head,
- the bolts (4) of the exhaust gas recirculation rigid
pipe from the exhaust manifold,
- the bolts (5) of the exhaust gas recirculation rigid
pipe from the exhaust gas recirculation rigid pipe,
- the exhaust gas recirculation rigid pipe,
- the seal between the exhaust gas rigid pipe and the
exhaust gas manifold,
- the seal between the exhaust gas recirculation rigid
pipe and the exhaust gas cooler.
REFITTING
I - REFITTING PREPARATION OPERATION
a
Tightening torquesm
bolts of the exhaust gas
recirculation rigid pipe
bracket on the cylinder
head
21 N.m
bolts of the exhaust gas
recirculation rigid pipe
on the exhaust manifold
36 N.m
bolts of the exhaust gas
recirculation rigid pipe
on the exhaust gas
recirculation assembly
12 N.m
lifting eye bolts 10 N.m
145641
135462
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.