Specifications

19B-18
EXHAUST
Intermediate pipe: Removal - Refitting
K9K
19B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Fit a component jack under the intermediate pipe.
II - REMOVAL OPERATION
a Cut the exhaust pipe using the tool (Mot. 1199-01) in
the centre of the areas to be cut (4) (see 19B, Ex-
haust, Exhaust: Precautions for the repair, page
19B-6) .
a Remove the rubber mounting bush (5) from the in-
termediate pipe using the tool (Mot. 1857).
a Remove the intermediate pipe.
Special tooling required
Mot. 1199-01 Exhaust pipe cutter (diame-
ter 35/50 mm and diameter
50/65mm). Complete kit in a
case.
Mot. 1857 Pliers for removing exhaust
pipe rubber mounting bushes
Equipment required
component jack
Tightening torquesm
exhaust sleeve bolts 25 N.m
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 19B, Exhaust, Exhaust: Precautions
for the repair, page 19B-6)
WARNING
To prevent the surrounding components from over-
heating, do not damage (tear, pierce, bend, etc.) a
heat shield.
Any damaged heat shields must be replaced.
IMPORTANT
Wear heat protective gloves during the operation.
146344
146343
Note:
If the rubber mounting bush is damaged, it must
always be replaced.