Specifications

10A-32
ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine oil: Draining - Refilling
K4M or K9K
10A
DRAINING
I - AVERAGE CAPACITY OF ENGINE OIL
a 4.7 litres (without oil filter replacement).
a 4.8 litres (with oil filter replacement).
a 4.0 litres (without oil filter replacement).
a 4.1 litres (with oil filter replacement).
II - RECOMMENDATIONS FOR REPAIR
a
III - PARTS AND CONSUMABLES FOR REPAIR
a parts always to be replaced: Drain plug seal on
engine oil sump.
a Consumable:
- Engine oil (see Engine oil: Specifications) .
IV - OIL SERVICE
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine oil filler cap (1) ,
- the dipstick.
a Place the oil recovery tray under the engine.
Equipment required
oil recovery tray
oil change wrench
torque wrench
oil change end piece with an 8 mm square drive
Tightening torquesm
drain plug 20 N.m
K4M
K9K
WARNING
Always check the oil level using the dipstick.
Do not exceed the maximum level on the dipstick
(could destroy the engine).
Correct the engine oil level if necessary before
delivering the vehicle to the customer.
Note:
When filling up the engine oil, always leave at
least 10 minutes for the oil to drain down before
checking with a dipstick.
144629