Specifications

10A-52
ENGINE AND CYLINDER BLOCK ASSEMBLY
Multifunction support: Removal - Refitting
K9K
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch side liner,
- the engine undertray bolts,
- the engine undertray,
- the front bumper (see Front bumper assembly:
Exploded view) and (see Exterior body front
trim assembly: Exploded view) (55A, Exterior
protection),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-2) ,
- the alternator (see 16A, Starting - Charging, Al-
ternator: Removal - Refitting, page 16A-1) .
a Remove the bolts from the power-assisted steering
pump on the multifunction support (without opening
the circuit) (see Power-assisted steering pump:
Removal - Refitting) (36B, Power-assisted steer-
ing).
a Attach the power-assisted steering pump to the front
end panel.
a Disconnect the air conditioning compressor connec-
tor.
a Remove the air conditioning compressor bolts (with-
out opening the circuit) (see Compressor: Remov-
al - Refitting) (62A, Air conditioning).
a Attach the air conditioning compressor to the lower
front cross member.
a Unpick the wiring harness on the multifunction sup-
port.
II - REMOVAL OPERATION
a Remove:
- the multifunction support bolts (1) ,
- the multifunction support.
Tightening torquesm
multifunction support
bolts on the cylinder
block
44 N.m
multifunction support
bolt on the sump
25 N.m
POWER ASSISTED STEERING, and STANDARD
HEATING RECIRCULATION
AIR CONDITIONING
19704