Specifications

10A-75
ENGINE AND CYLINDER BLOCK ASSEMBLY
Flywheel: Removal - Refitting
K4M
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
- the gearbox (see Manual gearbox: Removal - Re-
fitting) ,
- the clutch pressure plate (see Pressure plate -
Disc: Removal - Refitting) .
II - REMOVAL OPERATION
a Lock the engine using the (1) .
a Remove:
- the flywheel bolts,
- the flywheel,
- the.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the condition of the flywheel.
a On the crankshaft, clean the flywheel bolt threading.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the flywheel bearing face if reusing,
- the crankshaft bearing face.
a parts always to be replaced: Flywheel bolts.
a Coat the new flywheel bolts using FRENETANCHE
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products).
a
II - REFITTING OPERATION
a Refit the flywheel.
Tightening torquesm
flywheel bolts 25 N.m + 50˚ ±±
±±
6˚
107913
23325
WARNING
Do not remove the bolts (2) from the flywheel
drive plate.