Specifications

11A-2
TOP AND FRONT OF ENGINE
Accessories belt: Removal - Refitting
K9K, and STANDARD HEATING RECIRCULATION
11A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front wheel arch side liner,
- the front right-hand wheel arch liner partially (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the plastic shield underneath the diesel filter.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Auto tensioner
a Turn the accessories belt tensioning roller clockwise
at (2) using a 16 mm offset spanner.
a Remove the accessories belt.
a Remove:
- the accessories belt tensioning roller bolt (3) ,
- the accessories belt tension wheel.
Equipment required
offset spanner
Tightening torquesm
new accessories belt
tensioning roller bolt
40 N.m
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
WARNING
In order to avoid any refrigerant leaks, do not dam-
age (deform, twist, etc.) the pipe.
118158
135490