Specifications

11A-4
TOP AND FRONT OF ENGINE
Accessories belt: Removal - Refitting
K9K, and AIR CONDITIONING
11A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch side liner,
- the front right-hand wheel arch liner partially (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the plastic shield underneath the diesel filter.
II - REMOVAL OPERATION
a Rotate the accessories belt auto tensioner clockwise
using a 16 mm offset wrench.
a Remove:
- the accessories belt,
- the accessories belt tension wheel.
REFITTING
I - REPAIR PREPARATION OPERATION
a parts always to be replaced: Accessories belt.
a parts always to be replaced: Accessories belt
tensioning roller
a parts always to be replaced: Accessories ten-
sioning roller bolt
a To remove all deposits, use a brush to clean the
grooves of:
- the crankshaft pulley,
- the air conditioning compressor pulley,
- the alternator pulley,
a Refit a new tensioning roller fitted with a new bolt.
a Tighten to torque the tensioning roller bolt (40
N.m).
Tightening torquesm
tensioning roller bolt 40 N.m
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
WARNING
In order to avoid any refrigerant leaks, do not dam-
age (deform, twist, etc.) the pipe.
101878
WARNING
Only use brushes with plastic or non-corrosive
metal (brass) bristles.