Instructions

b) Door sensor

When a position sensor (NC - typical magnet sensor) is connected to the door, the code lock can

beconguredtodothefollowing:

• Automatically disable access

The sensor contact is broken when the door is opened. The outputs on the door lock are

disabled to prevent unauthorized access, even when the preset timer has not elapsed.

• Forced door alarm

The code lock triggers an alarm when the sensor contact is broken without using the door

opener or a correct access code. The alarm will sound for 60 seconds, or until a correct ac-

cess code is entered. Use program code 80 to enable the alarm.

• Open door alarm

The code lock triggers an alarm if the door is not closed within the preset time. Use program

code9tocongurehowlongthedoorcanstayopenbeforethealarmgoesoff(1–999sec-

onds).

• Communication between code locks:

Output 14 is switched to GND when the door is opened. This prevents other code locks from

accessing the door.

MAGNETIC

DOOR CONTACT

DOOR SENSOR