Instructions
e) Output 2
• Connects to an NC jumper
• Uses the NO output contacts to connect to an alarm system by bridging the NC system.
• Use program code 51 to place the output in start/stop mode.
• Enabling/disabling an alarm system
• The NO or NC output can be used to control an alarm system.
• Payattentiontoyouralarmsystemspecications.
• Use program code 51 to place the output in “Momentary” mode for multi-station systems, or
start/stop for single-station systems.
CABLE HARNESS
ALARM SYSTEM CONTROL PANEL
N.C. MAGNETIC CONTACT
TO A PROTECTED AREA WITH AN
ALARM SYSTEM
CONTACTS TO
ENABLE/DISABLE
NO OR NC
CONTACT
47