Instructions

6. Installation
• Check whether there are any cables or wires underneath the mounting surface. These may
be damaged when you drill holes into the surface.
Disconnect the wires from the mains and ensure that they cannot be switched back
on. Check that there is no voltage on the wires.
Take care not to short circuit the input and output wires. Keep the wires separate from
one another. Before connecting any wires or cables, turn off the power supply and
ensure that it cannot be switched back on by unauthorized personnel.
• Use the device as a template and mark the positions of the drill holes on the wall.
• Use a 3 mm drill bit to drill at least 10 mm into the markings.
Depending on the surface material or mounting position, additional parts may be re-
quired. These parts are not included in the assembly kit.
 Ensurethatthecrosssectionofthecablesissufcient.
 Beforewiringtheelectrics,checkthattheindividualwiresareconnectedandcong-
ured correctly. If in doubt, consult an electrician.
• Secure the enclosure to the wall using a wood screw.
• If necessary, remove the connector from the circuit board. Connect all of the necessary con-
tacts to the correct wire and strip the other wires.
• Insert the connector into the circuit board on the keypad. Clamp the wires into the screw
contacts and check that they are in contact.
• Insert the keypad into the enclosure and screw it in place with the machine screws.
7