Manual

Insert the print bed and magnetic mat.

Remove the styrofoam pads

1. Install the spool holder.

2. Slide the lament spool onto the holder.

1. Insert the lament tube in the feeder.

2. Insert the lament tube into the extruder.

System

Tool

1. Connect the mains cable to the power inlet on the printer.

2. Flip the power switch into the position I to switch on. The display lights up.

Quick Start Guide

FDM 3D Printer Pro 6+

Item No. 2583518

Read the safety instructions supplied

with the product before using

Set printer up

Calibrate Z-Offset

Insert the print bed and magnetic mat.

Open the menu Tools. Touch the button Preheating to start the pre-

heating process.

Wait until the preheat temperature has been reached.

Open the menu Manual. Touch to move the extruder to its zero posi-

tion.

Activate the Z-offset calibration with the slider. Touch the distance increment 0.1 mm to

activate it.

PAGE 1
2 Set printer up Calibrate Z-Offset Quick Start Guide FDM 3D Printer Pro 6+ Item No. 2583518 Insert the print bed and magnetic mat. Insert the print bed and magnetic mat. 3 4 Open the menu Tools. Remove the styrofoam pads 5 Touch the button Preheating to start the preheating process. 6 Wait until the preheat temperature has been reached. 1. Install the spool holder. 2. Slide the filament spool onto the holder. 7 1. Insert the filament tube in the feeder. 2.
PAGE 2
3 Load filament 4 Print CAUTION Hot print bed Touching hot print bed can cause burns Let cool down before touching Slide one sheet of A4 paper (80 g) between the nozzle and the print bed. Open the menu Tools. Open the menu Filament. 2 1 Slide the paper back and forth while repeatedly touching the button or to lift or lower the print bed. If you notice slight resistance between nozzle, paper, and print bed, touch the button to finish the calibration.