Specification

52
Fasten T-Slotted Brackets to top L-Channel using the L-Brackets
A. Slide T-Bolt (F) through the top of the T-Slotted Bracket (A) approximately 35mm (1.4in)
down. There is no need to place a spring washer, or regular washer through the T-bolt.
B. Feed thread of the T-Bolt (F) through L-Bracket (C) and angle T-Slotted Bracket (A) as
desired. The optimum angle will vary with your apparent position, relative to the sun.
Range is usually from 60-75 degrees from the vertical.
C. Once desired angle has been achieved, fasten the T-Slotted Bracket (A) down with bolt.
Be careful not to tighten too much, because it is possible to strip the T-Bolt.
D. Repeat process for both T-Slotted Brackets.
Figure 4
Note: It is important that the T-Slotted Brackets stay parallel. Nonparallel T-Slotted
Brackets will cause the panel to bend which can cause micro-fractures in panel.
A
F