Installation Guide

Attach Support Arm to bottom L-Brackets

A. Flush Support Arm (D) to L-Bracket (C) and align the holes.

B. Place washer on Support Arm (D) surface and align holes.

C. Feed a Cap Head Bolt (G) through Support Arm (D), and the L-Bracket (C).

D. Fasten it with small Nuts (K).

D. The orientation should be close to Figure 3.

E. Repeat for the other side.

Figure 3

Note: The reason for this is that depending on the angle that the T-Slotted brackets are

fastened to the top L-Channel, you may need to adjust the bottom L-Channel so that it will

be flush against the pole.