Phau Ntawv Qhia

ManualsBrandsRenogy ManualsPhosphate BatteryRENOGY RBT100LFP12S-US Lithium Hlau Phosphate Roj teeb

www.renogy.com

USER GUIDELINE

LITHIUM IRON PHOSPHATE BATTERY

Danger

High Voltage

Eye Protection

Must Be Worn

Emergency

Eye Wash

Risk Of Fire Highly

Flammable Material

Caution

ALWAYS wear protective

clothing and eyeglasses

while working with the

Lithium Iron Phosphate

Battery.

Any uncoverd battery

material such as electrolyte

or powder on the skin or in

the eyes must be flushed

out with plenty of clean

water immediately. Seek

medical attention

afterwards. Spillages on

clothing should be rinsed

out with water.

Terminals of the Lithium

Iron Phosphate Battery are

always live. DO NOT place

tools on them. DO NOT

short circuit or use outside

of the specified electrical

ratings.

DO NOT touch any

terminals or connectors to

avoid electric shock.

Safety Precautions

Please use circuit breakers, fuses, or disconnects that are appropriately sized by certified electricians, licensed installers, or

regional code authorities to protect all the electrical equipment in your system. The battery contains a battery management

system (BMS) that protects the battery cells from over-charge, over-discharge, and over-current, however this alone will not

protect your system from severe electrical conditions.

Please verify the polarity before connecting wiring. Reverse polarity can and will destroy the battery.

DO NOT short-circuit the battery terminals. Doing so can cause bursts in amperage and lead to irreversible damage to the

system and the battery (and possibly cause an explosion).

Please wear proper personal protective equipment when working on the battery.

DO NOT string batteries in series. Doing so can cause catastrophic failure.

Please ONLY connect identical batteries in parallel to ensure the best battery performance.

If the battery shuts off due to low state of charge, please disconnect the battery from your equipment to eliminate parasitic loads

and charge the battery as soon as possible.

It is highly recommended to pair the battery with low voltage disconnect devices in the system setup.

Renogy | www.renogy.com | techsupport@renogy.com | T: 909-287-7111 | F: 888-543-1164

Summary of content (4 pages)

PAGE 1
www.renogy.com USER GUIDELINE LITHIUM IRON PHOSPHATE BATTERY Danger High Voltage DO NOT touch any terminals or connectors to avoid electric shock. Eye Protection Must Be Worn Emergency Eye Wash ALWAYS wear protective clothing and eyeglasses while working with the Lithium Iron Phosphate Battery. Any uncoverd battery material such as electrolyte or powder on the skin or in the eyes must be flushed out with plenty of clean water immediately. Seek medical attention afterwards.
PAGE 2
www.renogy.com Battery Installation Safe and reliable installation requires trained and certified technicians. This section can only serve as a guideline as all scenarios cannot be covered. Wear protective clothing and eyeglasses Size the battery cables appropriately Use high stranded copper and heavy gauge cables to handle possible loads from the battery. Make sure to maintain identical cable lengths. Verify correctpolarity Reverse polarity can and will destroy the battery.
PAGE 3
www.renogy.com Battery Speciﬁcations Electric Characteristics Model RBT2450LFP Nominal Voltage 25.6V Rated Capacity（0.2C） 50Ah 1280Wh Energy Specific Energy 100.78Wh/kg ≤20mΩ Internal Resistance Cycle Life ＞3500 Cycles (25 29±0.2V Charge Voltage Charging Parameters ，0.2C，DOD 80%，EOL 80%) Maximum Continuous Charge Current 50A Charge Cut-off voltage Discharging Parameters Temperature Parameters 29.
PAGE 4
www.renogy.com Protection Circuit Module (PCM) Speciﬁcations Condition Battery Operation Status Battery Overvoltage Battery Cell Overvoltage Battery Undervoltage Battery Cell Undervoltage Charge High Temperature Disharge High Temperature Charge Low Temperature Discharge Low Temperature Charge Overcurrent Battery Voltage≥29.2V Recover Battery Voltage≤27.6V / Discharge current≥1A Trigger Battery Cell Voltage≥3.65V Recover Battery Cell Voltage≤3.