Installation Guide

Fasten L-Channels to L-Brackets

A. Place Washer (H) flush to top surface of L-Channel (B), and align the holes.

B. Slide the Spring Washers (I)) onto the Cap Head Bolt’s (G) thread so that the bottom face

of the Cap Head Bolt is touching the top surface of the spring washer.

C. Feed the thread of the Cap Head Bolt (G) through both L-Channel (C) and Washer’s hole.

Repeat for all 4 holes.

D. Align the L-Bracket (C) with the bottom face of the L-Channel (B) and feed the protruding

threads through the L-Bracket holes. Make sure the L-Bracket is flush and tighten bolts.

E. Fasten the L-Bracket (C) to L-Channel (B) with two small Nuts (K).

F. Repeat for both sets of L-Channel (B), fasteners, and L-Bracket (C).

Figure 1