Installation Guide

Install of Panel to RV Roofs

Installation on to the roofs of RV’s typically requires more specialized instruction due to the nature

of construction of most commercially available RV roofs. Please note that this section includes

the use of a fastener type NOT included in the Z-Bracket kit. This section is included for

convenience of customers installing to an RV roof. The instructions listed in this section are a

modification of the normal installation, all other steps are to be completed normally.

NOTE: A minimum roof thickness of 3/8” is recommended for this type of installation.

Additional components and tools required for this section:

Image

Component

Description

Well Nut

Special recessed fastener which expands

as the internal fastener is tightened. Allows

for fastener to seal within mounting surface

and embed itself tightly. Need variety with

at least #10-32 internal thread, material

thickness supporting roof thickness, and

3/8” hole size. A fastener with suggested

features can be found here:

http://www.mcmaster.com/#93495a190/=xf

p203

http://www.homedepot.com/p/Everbilt-10-

32-tpi-x-5-8-in-Brass-Expansion-Nut-

814358/204276054

Machine

Screw

Used to secure Z-Brackets to surface with

well nut. Must be compatible with chosen

well nut by having the same internal thread

and not longer than the length of the well

nut. Must also purchase compatible flat and

lock washers.

Phillips

Head Screw

Driver

Used to secure machine screw into well

nut.