Installation Guide
General safety instructions
10
!
!
!
!
!
2.2 Safety when installing the product
DANGER!
• Never mount the product in areas where there is a risk of gas
or dust explosion.
CAUTION!
• Ensure a secure stand!
The product must be set up and fastened in such a way that it
cannot tip over or fall down.
NOTICE!
• Do not expose the product to any heat source (such as direct
sunlight or heating). Avoid additional heating of the product.
• Set up the product in a dry location protected from splashing
water.
2.3 Safety when connecting the product electronically
DANGER! Danger of fatal electric shock!
• For installation on boats:
If electrical devices are incorrectly installed on boats, this can
lead to corrosion damage on the boat. Have the product
installed by a qualified (boat) electrician.
• If you are working on electrical systems, ensure that there is
somebody close at hand who can help you in emergencies.
WARNING!
• Make sure that the lead has a sufficient cross-section.
• Lay the cables so that they cannot be damaged by the doors
or the bonnet.
Crushed cables can lead to serious injury.
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
• Use ductwork or cable ducts if it is necessary to lay cables through
metal panels or other panels with sharp edges.
• Do not lay the AC cable and DC cable in the same conduit
(empty pipe).