Installation Guide

Us e c hargi ng conve rter
20
10 Use charging converter
10.1 Switch charging converter on/off
The charging converter turns on automatically as soon as it receives a positive
control signal. The status LED glows blue.
The charging converter switches off automatically when the control signal
is no longer present.
10.2 Adjust charging converter
You can adjust the device using the DIP switch (fig. 7, page 3).
Set switchover voltage/constant voltage
You can use the DIP switches S1 and S2 to set the value of the end-of-charge voltage.
NOTE
If the control signal of the charging converter is switched via the
ignition, the starter battery can discharge if the engine is not
started in a timely manner.
NOTE
Take the values for the charging end voltage and maintenance charge
voltage of your battery from the battery manufacturer's specifications.
S1 S2
Switchover voltage/constant voltage
12 V
ON ON
OF F ON
ON OFF
14.7 V
14.1 V
14.4 V
OF F OFF
1