Use and Care Manual

ManualsBrandsRenogy ManualsElectrical100-Watt 12-Volt Monocrystalline Solar Starter Kit with 40 Amp Rover MPPT Charge Controller

Battery GEL SEALED FLOODED LI (LFP) USER

Over-voltage

Warning

16 V 16 V 16 V 16 V

Equalization

Voltage

-----

14.6 V

Boost Voltage

Float Voltage 13.8 V 13.8 V 13.8 V -----

Boost Return

Voltage

13.2 V 13.2 V 13.2 V 13.2 V

Under Voltage

Warning

Under Voltage

Recover

Low Voltage

Disconnect

Low Voltage

Reconnect

12V 12V 12V 12V

12.2 V 12.2 V 12.2 V 12.2 V

Equalization

Duration

2 hours 2 hours

Battery Charging Parameters

Boost Duration

2 hours 2 hours 2 hours

-----

9-17 V

0-10 Hrs.

1-10 Hrs.

9-17 V

9-17 V14.8V

14.4 V14.6 V 14.4 V 14.2 V

11.0V 11.0V 11.0V 11.0V

12.6 V 12.6 V 12.6 V 12.6 V

*Battery charging parameters in USER mode can be programmed using the Renogy BT App.

**Default charging parameters in LI mode are programmed for 12.8V LFP battery. Before

using Rover to charge other types of lithium battery, set the parameters according to the

suggestions from battery manufacturer.

***Parameters are multiplied by 2 for 24V systems.

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.