Owners manual

Please Read The Following Instructions Before Installing:
www.rensup.com
Classic Z-pipe High Tank Toilet Conversion KIT
Preparation and disassembl
y
1.
Shut off water supply to the existing water closet
2. Disconnect water supply tubing from the existing tank and angle stop valve
3.
Remove existing toilet tank
4.
Leave existing toilet water closet bowl - optional
If you wish to if you wish to replace just the wax ring on the existing water closet bowl
see the optional instructions below, or if you want to replace the entire existing water
closet bowl read the optional instructions below.
Optional Toilet Bowl Install & Wax Ring Replacement
5. Remove the existing water closet bowl to
remove the old wax ring.
6. Remove old wax ring & clean area around drain
7. Draw a center line (as illustrated) through the
center of the drain to the wall.
8. Plumb line vertically to the wall up to 79”,
at this point draw a horizontal line on either
side of the center line.
9. To install the toilet bowl turn it upside-down.
Place the NEW wax ring (available at any
Hardware store) & sleeve over the drain horn.
Press it down firmly.
Note: if the ring has a paper cover, remove it
10. Make sure the toilet flange us clean & the floor
bolts point straight up. Carefully position the toilet
bowl over the flange, & fit the holes In the toilet
base directly over the floor bolts.
11. Press down on the toilet bowl to compress the wax
ring, to form a tight seal. Attach the washers &
nuts to the floor bolts, & tighten then with an
(non-scratch) adjustable wrench.
(Note: Don’t over-tighten the bolts as you
may crack the ceramic base
)
Toilet Bolt Covers are available at rensup.com
17612 White, 17613 Bone, 17614 Black
These instructions and drawings disclose confidential and other data of proprietary nature owned
by Renovator’s Supply Inc. and may not be used or disclosed to others without the prior written
consent of Renovator’s Supply Inc.©
ZpipeConv072010
Page 1