Installation guide

Installation Guide RN3000US Jan13
41
5.5.2 Network communication
You can connect inverter to Internet or PC by router (the router is not specified,
you can get any brand or model in the market).
Wiring procedure:
1) Connect the router to PC and internet.
2) Configure the router via PC.
3) Connect the inverter to router.
5.6 Closing the Digiwatts unit
When you have finished connecting the AC-output wires, the DC-input wires,
re-check all your connections to ensure that everything is in the right place and
that all connections and knockout fittings are secure. Check all of the knockout
fittings on the bottom of the Digiwatts unit to ensure that they provide a
weather-tight seal.
WARNING!
Never install the Digiwatts unit during rain or very damp conditions.
Because the Digiwatts unit is completely sealed, you must be sure no
moisture is trapped inside the enclosure when securing the lid
.
CAUTION!
Be careful not to misplace the machine screws or the gland that attach
the cover to the case, as all four screws and gland are required to ensure
that the cover is grounded properly and is fully sealed to the case.
Handle the cover carefully, as even seemingly minor damage to the cover
could result in an inadequate seal between the cover and the case, thus
allowing moisture to enter the case and damage the sensitive electronic
components.
Use the following procedure to replace the cover on the Digiwatts unit:
1) Check wire routing to ensure that no wires can interfere with proper