Installation guide

Installation Guide RN3000US Jan13
42
sealing of the cover and that no pressure will be exerted on the
connections when the cover is replaced.
2) Locate the four machine screws and gland you removed to take the cover
off the Digiwatts unit. Make sure you have all four screws and gland, as all
of this hardware is necessary to ensure proper grounding and a
weather-tight seal.
3) Check the seal on the inside of the cover to ensure it is undamaged and in
the correct position.
4) Carefully position the cover on the front of the Digiwatts unit so that the
four holes in the cover are aligned correctly with the four threaded holes in
the case.
5) While holding the cover in place, carefully insert the four machine screws
with lock washer, through the holes in the cover into threaded holes in the
case and turn them until they are finger-tight. Be careful not to
cross-thread any of the screws. Do not use power tools to start the screws.
6) Verify that the cover is in the correct position and that the seal is in place
between the case and the cover.
7) Tighten the cover screws.
6 Commissioning
WARNING!
Follow the steps in the commissioning procedure in the order they are
presented. Deviating from these procedures could expose you to lethal
voltages that can cause serious injury and/or death.
CAUTION!
Follow the steps in the commissioning procedure in the order they are
presented. Deviating from these procedures could cause irreversible
damage to the Digiwatts unit and void the warranty.