Installation Guide

6
5mm (1/4")
3mm (1/8")
6
Measure the width of the hem at the
bottom of the skirt (fig. 6).
Trace an outline of the inside skirt
according to the measurement, following
the dimensions of the previous outline
(fig. 7).
Mesurer la largeur du rebord de la jupe
(fig. 6).
Transposer cette dimension sur le tracé
fait précédement (fig.7).
Medir el ancho del borde en la parte
inferior de la bañera (fig.6).
Trazar el contorno de la falda interna de
acuerdo a la medición, siguiendo las
dimensiones del contorno previo (fig.7).
5mm (1/4")
3mm (1/8")
Fig. 6 Fig. 7
Skirt
Jupe
Falda
Fig. 4 Fig. 5
5
Place the bathtub in position and proceed
to make it level (fig. 4). Make sure there
is a gap of at least 3mm (1/8’’) between
the skirt and the floor. The skirt should
not rest on the floor (fig. 5).
Placer la baignoire dans son emplacement
et procéder à la mise-à-niveau
(fig.4).S’assurer d’avoir un dégagement
d’au moins 3mm (1/8’’) entre le
plancher et la jupe de la baignoire. La jupe
ne doit en aucun cas s’appuyer sur le
plancher (fig.5).
Colocar la bañera en su posicion y
continuar con su nivelacion (fig.4).
Asegurarse de que exista un espacio
libre mínimo de 3 mm (1/8’’) entre
la falda y el piso. La falda no debe
descansar sobre el piso bajo ninguna
circunstancia (fig.5).
5mm (1/4")
3mm (1/8")
Outine of skirt hem
Tracé du rebord de la jupe
Contorno del borde de la falda