User guide
12
On/O Function
Your ReSound BTE is equipped with an on/o switch inte-
grated into the battery compartment. When the battery
compartment is fully closed, the instrument is turned on in
its functional mode and programme 1 will be activated. Par-
tially open the battery door until it snaps into the o-position.
The instrument is then switched o. Whenever you are not
wearing the instrument, remember to turn it o to reduce
battery consumption.
SmartStart
SmartStart allows you to insert the instrument in the ear
without annoying sounds like squealing. It delays the switch
on time 10 seconds after closing the battery compartment,
and is indicated by a beep every second after closing the
battery compartment.
Volume Control
The ReSound models 60-VI, 7ODV, 70DVI and 80-DVI oer
a volume control allowing you to turn the volume up and
down. When wearing the instrument, you can increase the
volume by turning the volume control wheel up, and reduce
volume by turning it down.
For each volume step, you will hear a “beep” signal indicat-
ing the change. If you reach the upper or lower limit of the
volume control range, there will be a dierent type of “beep”
signal with a lower pitch.
Please note that your instrument has been tted by your
hearing care professional and that your hearing loss has re-
quired a certain amount of amplication. This means that
you may not be able to increase the volume as much as you
can decrease it.