Instructions / Assembly

A. Headboard Top (1 pc) B. Footboard (1 pc) C. Side Rail (4 pcs)
C1 C2
G.
Side Rail Support (4 pc)
I. Center Leg (4 pcs)
D. Headboard Leg (2 pcs) E. Footboard Leg (2 pcs)
H. Slat (4 pcs)
IMPORTANT NOTE:
Carefully remove all the parts from the box. Arrange on a at
surface and verify you have all of the following parts and hardware.
PARTS LIST
HARDWARE LIST
(Continued on back)
STEP 1
STEP 3
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
Phillips Screwdriver
A
A
Attach Headboard Legs (Part D) to the Headboard (Part A) using three
50mm Bolts (Part M) and three Spring Washers (Part Q) per leg. Secure
tightly using Large Hex Key (Part N).
Attach the eight 16mm Bolts (Part J) to the headboard leg
brackets and footboard brackets using the Small Hex Key (Part O).
Do not tighten.
Attach the four Side Rail Supports (Part G) to the Side Rails (Part
C1 and C2) using twelve 30mm Bolts (Part K) and Large Hex Key
(Part N). Tighten the bolts.
L. 35mm Bolt
(4 pcs)
M. 50mm Bolt
(8 pcs)
N. Large Hex Key
(1 pc)
K. 30mm Bolt
(20 pcs)
R. Flat Washer
(8 pcs)
P. 32mm Screw
(8 pcs)
Q. Spring Washer
(6 pcs)
J. 16mm Bolt
(8 pcs)
O. Small Hex Key
(1 pc)
N
B
F. Side Rail Leg (2 pcs)
A
D
D
K
G
Unzip the black fabric on the back of the headboard and remove
the parts. Zip the black fabric closed after parts are removed.
Attach the Footboard Legs (Part E)
to the Footboard (Part B) using two
50mm Bolts (Part M) and Large Hex
Key (Part N). Secure tightly.
C1
C2
N
M
D
Q
A
N
E
M
J
O
STEP 2
B