C363, C363DT, C563, C763, C563DT, C383, C583, C783 In-Ceiling Architectural Loudspeaker Instruction Manual
DOCUMENTATION CONVENTIONS This document contains general safety, installation and operation instructions for the Revel® C783, C583, C383, C763, C563, C363, C563DT, C363DT in-ceiling loudspeakers. It is important to read this document before attempting to use this product. Pay particular attention to: WARNING: Calls attention to a procedure, practice, condition or the like that, if not correctly performed or adhered to, could result in injury or death.
LOUDSPEAKER PLACEMENT FOR DISTRIBUTED SOUND s Since distributed sound is general sound throughout an area, place the loudspeakers as uniformly as possible for even sound coverage throughout the area. s Place the left and right loudspeakers roughly the same distance from the primary listener locations. s To avoid “hot spots” where the sound is too loud, plan to use more loudspeakers, with each set to play at a lower volume.
LOUDSPEAKER PLACEMENT FOR DUAL-TWEETER STEREO MODELS Because a single Revel dual-tweeter stereo in-ceiling speaker reproduces both stereo channels from a single location, it will deliver outstanding performance from a wide variety of mounting locations where a pair of stereo speakers would be impractical, including hallways, bathrooms and closets. INSTALLATION INSTRUCTIONS CAUTION: Do not use the tweeter-mounting baffle as a handle to move, carry or position the speaker. Doing so can damage the baffle.
MOUNTING THE SPEAKERS For New Construction If you wish to pre-install a rough-in frame for the speakers before the drywall is installed in new construction, you will need to purchase the correct rough-in frame kit for your loudspeaker model from your authorized Revel dealer. Detailed mounting instructions are supplied with the rough-in kit. After the drywall is installed, follow the installation instructions in For Existing Construction, below. 4.
7. Insert the speaker straight into the mounting opening. Tighten the speaker clamp screws on the front of the speaker baffle. The speaker clamps will automatically rotate into position and begin clamping the speaker. s 7HEN YOU NOTICE RESISTANCE ON THE SCREWS THE SPEAKER HAS BEEN clamped successfully. IMPORTANT: Always use low-torque settings.
EXCESSIVE OUTPUT LEVELS High-Frequency Level Control (C783/C763/C583/C563) The High-Frequency Level control lets you fine-tune the speaker’s highfrequency output to compensate for various acoustical environments.
www.revelspeakers.com © 2012 HARMAN International Industries, Incorporated All rights reserved. Revel and the Revel logo are trademarks of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance are subject to change without notice. For questions, assistance or additional information concerning any of our products, call us at: (516) 594-0300 or (888) 691-4171.
LIMITED WARRANTY United States, US Territories – Effective January 1, 2017 This limited warranty (this “Limited Warranty”) protects only the original end-user (“you” or “your”), and is not transferable. Any attempt to transfer this Limited Warranty shall immediately make this Limited Warranty void.
