W363, W563, W763, W553L, W383, W583, W783, W873, W893 In-Wall Architectural Loudspeaker Instruction Manual
DOCUMENTATION CONVENTIONS This document contains general safety, installation and operation instructions for the Revel® W893, W873, W783, W583, W383, W763, W563, W363 and W553L in-wall loudspeakers. It is important to read this document before attempting to use this product. Pay particular attention to: WARNING: Calls attention to a procedure, practice, condition or the like that, if not correctly performed or adhered to, could result in injury or death.
Although the Revel W553L is designed for use primarily as front left, center and front right speakers in a home theater system, the high-order crossover networks employed in all Revel in-wall speakers provide very smooth response over a wide listening area, allowing you to use any model in any application with excellent results. Note: All Revel in-wall speakers, including the W553L, can be used in either horizontal or vertical orientation. 5.1-Channel Surround Speaker Placement s In a 5.
INSTALLATION INSTRUCTIONS Revel architectural speakers are extremely easy to install. However, if you are unable to understand and follow the instructions in this manual clearly and fully, or if you are unsure of your ability to install these loudspeakers properly, please contact your dealer or a qualified installer.
2. Determine the correct speaker location and use the template included with the speaker to mark the wall material. 5. Make sure all of the speaker clamps are retracted in their “ready-tomount” position at the tops of the mount towers, tucked within the mounting opening's border. C2 Speaker Clamps in Ready-to-Mount Position 6. Insert the speaker straight into the mounting opening. Tighten the speaker clamp screws on the front of the speaker baffle.
7. Attach the supplied grille. Powerful magnets in the speaker frame will securely hold the grille in place. Be sure that it is attached evenly, and that the edges of the grille extend over the baffle on all sides. Adjusting the tension of the speaker clamps so that the speaker frame is flat will help ensure that the grille contacts the wall all the way around the speaker for a proper fit.
OBTAINING SERVICE To obtain service, contact an authorized Revel dealer. Refer to Limited Warranty, below, for more information.
HARMAN International Industries, Incorporated 8500 Balboa Blvd., Northridge, CA 91329 www.revelspeakers.com © 2012 HARMAN International Industries, Incorporated. All rights reserved. Revel and the Revel logo are trademarks of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance are subject to change without notice.
