Operation Manual

GB-28

Assembly

STEP 3

STEP 4

1. Connect the upper computer cable to the lower com-

puter cable (40 + 9) as well as both traction cables

(6 + 8).

2. Then push the handlebar support tube (7) with cover

(68) onto the main frame (26). Make sure not to

pinch the computer cable.

3. Now fasten the handlebar support tube (7) with four

M8 screws (10) and four M8 washers.

4. Then clamp the handlebar in the handlebar locking

clamp.

5. Set the front handlebar cap (75) together with the

spacer sleeve (15) over the handlebar locking clamp

(12) and ﬁ x the handlebar cap (75) with the large

wing screw (16).

WARNING

1. Connect the computer cable of the console (4) to the

computer cable of the handlebar tube (13).

2. Lay excess cable in the handlebar tube.

3. Now fasten the computer console with four M8 x 20

mm screws (72).

4. Then fasten the rear handlebar cap with two M4

screws (70) and two M5 screws (71). Make sure that

you lay the pulse sensor cable over the rear handle-

bar cap.

5. Insert the connection of the pulse sensor into the

socket on the rear side of the computer console.

WARNING

Assembly

REX_Trainer_BX200_12.indd GB-28REX_Trainer_BX200_12.indd GB-28 02.05.12 08:1002.05.12 08:10