Submittal

ManualsBrandsReznor ManualsHeating200,000 BTU High Intensity Gas Fired Heater Natural Gas

Page 12

Page __________ of __________

NOTE: Not approved for outdoor use.

DESCRIPTION

Reznor High Intensity Infrared Models RIH, RIHV are designed to pro-

vide personal comfort heating with reduced energy cost. Units are available in

sizes from 30,000 through 200,000 BTUH gas input for use with natural gas

and sizes from 50,000 through 120,000 BTUH gas input for use with propane.

Infrared heaters can best be compared to the sun in how they heat. On a

bright sunny day, you can feel the infrared rays of the sun heating your skin

surface. The same infrared rays are also heating the concrete sidewalks and

buildings. Infrared heating equipment works the same way - it warms people,

heats floors, walls, machinery and other surfaces, without heating the air

between. The “infrared heated” objects in turn warm the surrounding air.

Eliminated are the costly ceiling heat losses and discomforts of cold air strati-

fication that are so familiar with conventional forced air heating systems.

Infrared heat assures floor level comfort with fuel savings up to 50%. Electri-

cal energy is also saved because there is no need for a fan or blower.

In addition to the gas and electric energy savings, infrared heaters have

other economical installation and operational features. Model RIH, RIHV

heaters can be suspended by chains from a joist or mounted to a wall, making

them well suited for space or spot heating. Direct venting is not required.

Operational service and maintenance requirements are minimal due to the

absence of moving parts.

Some sizes can be ordered with optional 2-stage heating. The first stage

will fire at 1/2 or 2/3 of total capacity. If more heat is required second stage will

fire for full capacity. A 2-stage thermostat must be used with 2-stage heaters.

Two-stage operation provides fewer on/off cycles for improved comfort and

longer life.

Model RIH, RIHV high intensity infrared units are design certified for use

in The United States and Canada by the Canadian Standards Association (CSA).

STANDARD FEATURES

• 115 volt operation for single-stage models, 24 volt operation for 2-stage

models

• Direct spark ignition, 100% safety shut-off

• Solenoid gas valve, 1/2” NPT inlet

• Ceramic combustion surface temperature up to 1850°F, capable of reaching

full intensity temperature in less than 30 seconds

• Seamless aluminized steel plenum chamber with stainless steel ceramic tile

retainer clips

• Venturi mixer of spun metal construction for precision metering of air/gas

mixture

• Highly polished aluminum reflector

• Balanced suspension holes, 3/8” diameter

OPTIONAL FEATURES

• Limited lifetime warranty available on burner

• Parabolic reflector

• Wire grid for increased radiant efficiency

• Protective screens for standard reflector or parabolic reflector

• Heat deflector shield (to reduce required clearance above the heater) only

available on 60 and 100 sizes

• 120/24V Thermostat (50° - 90°F)

• 2-Stage heating on sizes 90, 100, 120, 150

• 2-Stage 24V thermostat for use with 2-stage heaters only.

• Stainless steel flexible connector (24”) with manual valve

• Chain (50 ft.) with 14 “S” hooks

• Chain mounting kit (pre-assembled for one heater) for mounting heater at

a 30° angle

RIH, RIHV Gas Fired High Intensity Infrared Heaters

for Indoor Commercial-Industrial Use

RIHN30

RIHVN200

ANSI Z83.19

CAN 2.35

Summary of content (5 pages)

PAGE 1
Page __________ of __________ ® RIH, RIHV Gas Fired High Intensity Infrared Heaters for Indoor Commercial-Industrial Use RIHN30 RIHVN200 ANSI Z83.19 CAN 2.35 NOTE: Not approved for outdoor use. DESCRIPTION STANDARD FEATURES Reznor High Intensity Infrared Models RIH, RIHV are designed to provide personal comfort heating with reduced energy cost.
PAGE 2
Page __________ of __________ ® TECHNICAL DATA NATURAL GAS MODELS RIHN 30A RIHN 60B RIHVN 100C RIHVN 150C RIHVN 160 RIHVN200C 30 60 100 150 160 200 MBH HEATING INPUT 8.8 17.6 29.3 44.0 46.9 58.6 kW 7 7 7 7 7 7 " w.c. MINIMUM INLET GAS 17 17 17 17 17 17 mbar PRESSURE 14 14 14 14 14 14 " w.c. MAXIMUM 35 35 35 35 35 35 mbar ALLOWABLE MOUNTING ANGLE 0 - 30 deg. 0 - 30 deg. 5 - 29 deg. 0 - 30 deg. 5 - 29 deg. 0 - 30 deg. (in degrees) GAS CONNECTION SHIPPING WEIGHTD A B C D in. mm Lbs.
PAGE 3
Page __________ of __________ ® Clearance from Combustibles/Installation Models RIH/RIHV - High Intensity Infrared Heaters Side Clearance Back Clearance Top Clearance Mounted 0-29° (no heat deflector) Mounted 30° only (no heat deflector) Mounted 0-30° with Heat Deflector, Option DO2 or DN4 Below Clearance Standard Reflector With Parabolic Reflector, Option DM2 or DN4 A B C RIHN 30A 30 inches 762 mm 30 inches 762 mm Clearance from Combustibles (See diagram below) Natural Gas Models Propane Gas Models RIH
PAGE 4
Page __________ of __________ ® Location/Installation Models RIH/RIHV - High Intensity Infrared Heaters MODEL RIHN 30 RIHL 50 RIHN 60 RIHVL 90 RIHVN 100 RIHVL 120 RIHVN 150 RIHVN 160 RIHVN 200 MOUNTING ANGLE MUST BE WITHIN THE TOLERANCE ALLOWED ALLOWABLE MOUNTING ANGLE RANGE IMPORTANT HORIZONTAL to 30 deg. When angle mounted, all RIHV Models must HORIZONTAL to 30 deg. be installed with the gas manifold on the lower HORIZONTAL to 30 deg. end. 5 to 29 deg. 5 to 29 deg.
PAGE 5
Page __________ of __________ ® Sample Specifications Models RIH/RIHV - High Intensity Infrared Heaters Provide gas-fired, high-intensity infrared heaters manufactured as Reznor brand units. The heaters shall be equipped for use with natural (propane) gas to operate on a 115 volt supply voltage [25 volt supply voltage]. The burner control system shall have a direct spark ignition with 100% safety shut-off and a solenoid gas valve with 1/2” NPT inlet. Heater shall have single-stage [two-stage] heating.