Instructions / Assembly

60
INSTALLATION INSTRUCTIONS
Electrical
Connecting the Remote Control to the Water
Heater:
Ensure that the power to the water heater has
been disconnected.
Loosen the one screw located on the remote
control connection cover. The connection cover
is made of white plastic.
NOTICE: DO NOT REMOVE FRONT
PANEL. Remote control wires are connected on
the bottom of the unit.
There are no accessible remote control
terminals inside the water heater.
Connect the remote control extension cables
from the remote control to the remote control
connection terminals.
NOTICE: The remote control wire
connection terminals are not polarity-sensitive.
Firmly tighten the terminal screws by hand.
Secure the remote control extension cable on
the hook located on the side of the remote
control connection base.
Reinstall the remote control connection cover
and secure with the one screw.
NOTICE: Do not connect power until
venting installation is complete.
Switch on the power supply to the water heater.
Check for proper operation of the remote
control and the water heater.
1
3
4
Remote Control
Connection Cover
Remote Control
Connection Cover
2
5
6
7
Electrical Wiring (cont.)