User Manual
Punching Paper:
u Select an appropriate number of sheets to be punched and slide the sheets
down vertically (Horizontally for the HD7700H and HD7500H) into the opening of
the die assembly. When the paper is fully inserted, slide it to the left so it comes
in contact with the paper stop. Make sure all the edges of the sheets are flush
by tapping the top and the right hand sides of the sheets before activating the
punch.
If a paper activated switch is being used, tap the sheets flush before
sliding the paper to the paper stop.
Note: Acetate and vinyl covers will require reducing the number of sheets being punched. It is
recommended that only 2-3 sheets of 6 mil acetate be punched during any single cycle of the machine. Attempts
to punch more than the recommended amount may lead to an incomplete punch or stall of the
machine. Repeated attempts to punch more than the recommended amount may also lead to
machine damage.
Removing Paper Waste:
u The paper waste drawer is located conveniently on the front of the punch. The
paper waste drawer is removed by lifting up on the front and pulling out away
from the machine. This drawer should be checked frequently while punching
and emptied as necessary.
Paper Jam:
u
If the
punch does not reset itself back to its home position, the punch can be reversed
manually.
The HD7700/H, HD7650, HD7100, HD7000, HD7000 Plus, HD6500, HD6700
and HD7500/H punches use a circuit board for controlling the punch cycle, this
circuit board also has the ability to automatically reverse the punch pins to their
starting position in the event of a paper jam. This condition could happen if too
much material has been attempted to be punched at one time. If this condition
occurs, the machine will attempt to reset itself back to its home position.
10
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.
u Turn the machine power switch off and remove
some or all of the material in the punch.
It is easier to remove one or two sheets at a time from the backside of the
material in the punch, top side for the HD7700H and HD7500H.