User Manual

u
u
u
HD7500/H Manual Reverse
- HD7500H -
This machine is
heavy and requires two people to move.
- HD7500H -
utilizes two
reversing tools supplied with the punch.
Remove the paper waste drawer from the machine.
Remove the power cord and foot-pedal from the back of
the machine. Rotate the machine onto its backside.
Remove the silver plugs from the panel of the machine by prying
them out gently with a small flat tool. Insert the ends of both
reversing tools into the open holes and engage the tools with the
ends of the motor shafts. Rotate the tools at the same time,
clockwise 5-10 revolutions, until the punch pins have been retracted
back to the starting position. Remove all of the material from the
punch.
It is easier to remove one or two sheets at a time from the
topside of the material in the punch.
Remove the reversing tools from the punch and replace the silver
plugs.
Rotate the machine back onto its feet and plug the
power cord and foot-pedal into the back of the machine.
Plug the power cord into the wall outlet and turn the power switch on.
Test cycle the machine by punching with no material in the punch, the
machine will reset itself back to its home position. Reduce the amount
of material being punched and continue working.
Turn
the machine power switch off and
unplug the power cord from the wall
outlet.
u
u
u
12
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.