Specifications

2 Digital Physician Operation Instructions
2.0 Scale Assembly
2.1 Unpacking Your Scale
Place the unopened box in an open area that ample room for unpacking the scale.
Parts contained in the shipping box include:
• The scale
• This manual
• AC adaptor (in white box).
• Scale feet
2.2 Repacking
If the Digital Physican Scale must be returned for modification, calibration or repair, it must be properly packed
with sufficient packing materials. Whenever possible, use the original carton when shipping the scale back.
NOTE: Damage caused by improper packaging is not covered by the warranty.
2.3 Setting Up Your Scale
Use the following steps to set up the Digital Physician Scale. Setup is basically the same for all three models.
Tools needed for setup include:
• 6 mm hex Allen key (included)
• 4 mm hex Allen key (included) - needed for height rod only
Use the following steps to set up the scale.
1. Locate the operator’s manual from inside the box and set
aside as it will provide instructions on the
proper scale removal and set up.
2. Carefully lift the scale out of the packaging material that
it came in - lifting it out by the scale base.
NOTE: DO NOT lift the scale out of the box by just the scale column. This could cause the hinge to break.
3. Move the scale into the area where the weighing process will occur. It’s recommended to place the scale
on a hard, level surface for the most accurate weighments. Thin carpeting is fine but not recommended.
4. Attach the scale feet to the bottom of the scale base by
screwing them into the scale base until snug. The
level bubble on the scale base should indicate that the scale is level. If not, screw out scale feet until
bubble becomes centered.
Figure 2-1. Bubble Should be Centered to Indicate that the Scale is Level
5. Loosen hex screw on waist and eye level models.
6. Unfold and set upright.
7. Tighten the hex screw head very firmly into the hinge
at the base of the scale using the 6 mm Allen key
to help stabilize the scale.
8. Assemble the height/measuring rod (
for the eye level model only).
Insert the rod into the pillar base slot
and feed the screw into the hole. Using the 4 mm Allen key, tighten
the height rod to the scale from the back.