User Manual - Version 2.2 Manual

10 Counterpart User Manual
Table 2-3. J4 and J5 Pin Assignments
An additional port (Port 3) is available if needed through the installation of an option card at J14.
2.7.2Digital I/O
The Digital I/O can be configured as either digital inputs or digital outputs as determined by the
Digital I/O menu (see Section 3.6.5 on page 36). The inputs are active (on) with low vo
ltage (0 VDC) and can be
driven by TTL or 5V logic without additional
hardware. Use the Digital I/O menu (see Section 3.6.5 on page 36)
to configure the digital inputs. LEDs on
the CPU board light when digital inputs are active (see Figure 2-5).
Digital outputs are typically used to control relays that drive other equ
ipment. Outputs are designed to sink not
source, switching current. Each output is a CMOS circuit, capable of sinking 24 mA when active. Digital outputs
are wired to switch relays when the digital output is active (low, 0 VDC) with reference to 5 VDC supply. LEDs
on the CPU board light up when the digital outputs are active (see Figure 2-5).
Table 2-4. J3 Pin Assignments (Digital I/O)
2.7.3 Network Connection to Counterpart
Counterpart has an onboard Ethernet connection. It’s wireless connectivity is made possible with the optional
Lantronix WiPort wireless networking device (PN 108671). Refer to the WLAN installation instructions (PN
108680) included with the option card for installing and configuration instructions.
Figure 2-5. LED Light Locations
Note: The Ethernet LED light is on when connected at 100 mb/s and is off when connected at 10 mb/s.
J5
1 Ground
1
2 Ground
3 Tx
4 Rx
5 DTR
6 RTS
Connector Pin Signal
J3
1 +5V
2 Ground
3 DIG I/O 1
4 DIG I/0 2
5 DIG I/O 3
6 DIG I/O 4
Connector Pin Signal Port
Note
LED
LED
JP1 JP2
JP3 JP4
JP5 JP6
PC1
WD1R
U
N
P
G
M
PWR
+5+3.3v
C3
ON SW
ISP
RST
Port 3 LED
Port 1 & 2 LED lights
Port 3 LED
Ethernet LED
Light